The CB750A Automatic SOHC 1976-1978 Hard Tail section comes complete as a slip-on and weld component, to make
it quick and easy for the builder. The rear lower and rear upper motor mounts are already located and installed so you
can bolt in and go!
A 5" ride height for better ground clearance and 2" rear stretch have been incorporated
in to the design of the standard hard tail section for your riding pleasure. Optional stretches and ride heights are available
upon request.
The standard hard tail section comes with 3/4" V style axle plates to accommodate most HD wheels pre
99. 1" axle plates are available upon request for the later HD and Sport wheel applications.
For those wanting
to use the stock Honda rear wheels 20mm slotted axle plates are available in both V-style and HD vintage style upon request.
Axle adjusters for V style axle plates are stock HD OEM 41576-36 and available for $ 8.99, vintage style axle plates adjusters
are available for $ 6.99.
The tubing wall is upgraded from stock to DOM and uses both 1 1/8" DOM and 1 1/2"
DOM with a heavier wall thickness for the backbone. The seat pan is installed and included in the standard kit. The
OD of the stock tubing and the DOM are the same for a nice clean look!
A complete instruction sheet is included for the
3 cuts and then all you need is a licensed/certified welder for the 3 joints and now you have a hardtail! Options
available for the hard tails sections include HD vintage style axle plates, 20mm axle slots, and an additional rear stretch
in 2" increments. |
